Steps to make an LED Light Tube

[yunaoled]

Make an LED light tube to embellish any special occasion. This LED Ceiling Light tube works from the wall socket and may also plug right into a car's cigarette lighter. Begin using these tubes for parties, on vehicle camping-outs, or problems. Personalize the colour from the tube as well as the size of the cord to suit your needs.

1

Buy a baton tube situation (see Assets) custom cut to at least one feet. Take away the finish caps.

2

Slide the tube within the dowel fishing rod. Tie a bit of dental start flossing to the dowel fishing rod at both finishes to hold the tube up from the rafter in the spare room or any other appropriate place.

3

Spray fresh paint the tube gently by having an even coating of whitened fresh paint. To find the even coating, turn the tube carefully making use of your finger within the tube. Permit the fresh paint around the tube to dry.|12W LED Ceiling Light

4

Cut the wire from the interconnect cable in two between your plugs situated at either finish. Strip the finishes from the wire you simply cut.

5

Plug the cut and removed interconnect cable connects to the plugs at either finish from the light strip.

6

Solder the wires together at one finish and cover the expose part wire with electrical tape. Coil in the wire. Make use of a hot glue gun to glue this wire under an finish cap.

7

Place the sunshine strip in to the tube and set around the finish cap, sealing it in position having a hot glue gun. Take care not to melt the tube using the warmth.

8

Drill an opening in to the finish from the remaining finish cap using the ?-inch drill bit. Cut an overall length of extension cord towards the length that you want.

9

Strip the finish of the extension cord and strip the wires inside at both finishes. Thread the good and bad wires in one finish with the hole and solder these to the leads around the interconnect wire (aside from the floor wire that is left free).

10

Tie a little overhand knot in to the cord over the hole and glue the knot and additional wire towards the finish cap. Glue the finish cap in position.|21W LED Ceiling Light

11

Strip wires resulting in a cigarette lighter plug and solder it towards the finish from the wires being released of sleep issues from the extension cord.

12

Fresh paint the bond with liquid electrical tape to cover any uncovered wires. Purchase a universal AC to Electricity ripper tools that will help you to connect the cigarette lighter plug in to the wall.